Keep just the part you want from a song, a voice note or a recording, with a soft fade at either end if you like.
Settings
Good to know
What cutting does to your audio
- Length
- What happens: Only the part you keep, minus anything you remove; with Speed above or below 1×, shorter or longer by that much
- Format
- What happens: Your file's own: MP3 stays MP3, M4A and AAC come out as M4A, WAV, FLAC and OGG stay; Opus comes out as OGG (Vorbis). A video's sound and anything else become MP3 unless you pick another
- Quality
- What happens: MP3 and M4A at 192 kbps; WAV (16-bit) and FLAC keep every sample, OGG uses Vorbis quality level 6
- Sample rate
- What happens: Your file's own, at most 48 kHz in MP3 and M4A and 192 kHz in WAV, FLAC and OGG
- Mono or stereo
- What happens: Kept as it is
- Joins
- What happens: Where a part or a silence is taken out, the two sides meet right at the cut, without a fade
- Video, cover picture
- What happens: Left out: only the sound is saved, from the file's first sound track
Which setting does what
- What to do
- Choices: Keep, Remove
- What it does: Keep saves the part between the handles; Remove takes it out (a cough, a mistake, an ad) and joins the rest
- Save as
- Choices: MP3, M4A, WAV, FLAC, OGG
- What it does: MP3 and M4A about 1.4 MB a minute; WAV about 10.6 MB a minute for a 44.1 kHz stereo song; FLAC keeps the same sound smaller than WAV; OGG's size follows the sound
- Fade
- Choices: In and out, None
- What it does: 1 second rising from silence at the start and falling to silence at the end; at most half the result, so a short clip still has both
- Find silences
- Choices: Silence level -60 to -20 dB (starts at -40)
- What it does: Marks every pause at least 0.7 seconds long that is that far under the loudest moment; shorter gaps, the ones between words, stay. Raise the level when pauses with some noise in them are missed
- Found silences
- Choices: Cut, Keep
- What it does: Cut takes out every marked pause but 0.15 seconds on each side, so the ends of the words around it stay whole: a 2-second pause loses 1.7 seconds
- Volume
- Choices: -20 to +20 dB
- What it does: Louder or quieter; a boost passes through a limiter, so loud moments don't clip
- Speed
- Choices: 0.75×, 1×, 1.25×, 1.5×
- What it does: Faster or slower with the voice at its own pitch; the length changes by the same amount
- Sources
- Xiph.Org: FLAC features
What people cut
The 25 seconds of a 3-minute voice note that matter, as MP3: about 0.6 MB, small enough for a chat message. A 30-minute podcast recording with 40 two-second pauses: Find silences cuts 1 min 8 sec in all and it comes out at 28 min 52 sec, with the words around each pause kept whole. A 60-minute lecture at 1.5× to hear on the way: 40 min, the voice at its own pitch.
Your files stay on your device
How to cut an audio file
Choose a song, recording or video: MP3, M4A, WAV, FLAC, OGG, Opus or AAC, or a video whose sound you want, up to 2 GB in Chrome or Edge on a computer, 1 GB in Safari on a Mac and 500 MB on a phone. Mark the part on the timeline: drag the two handles to the start and the end. The preview plays the part again and again. In Settings, under "What to do", Keep saves only that part; Remove takes it out and joins what comes before and after. For times to the tenth of a second, type them under "Exact times", like 1:05.5. Still in Settings, pick "Save as" (your file's own format is already chosen) and set Fade to "In and out" if the ends start or stop too suddenly. Then press "Cut audio" in the bottom bar. The line beside the button shows how long the result will be before you start; your original file stays as it was.